A PRACTICAL NOTE · Troubleshooting

How to apply this guide

Recover from microphone routing changes after a call without changing your speech model.

Start with

After the call ends, check Sound Input and say a test sentence. Confirm the device name and input level. If a headset uses a call profile, test with a USB or built-in mic to isolate the route.

Check before you finish

Repeat the same phrase once the meter is steady. If the original reads correctly but an email draft changes it, the remaining issue is formatting rather than the call’s microphone route.

Evidence to keep: Record the expected sentence, actual result, microphone, language, model and app build before changing settings. This page’s key limit is: Recover from microphone routing changes after a call without changing your speech model.

Start here

Headset mode, external displays and conference controls can change the path to the microphone. A recognizer that worked earlier in the day can then receive a weak or different signal.

Verify the input after leaving

After the call ends, check Sound Input and say a test sentence. Confirm the device name and input level. If a headset uses a call profile, test with a USB or built-in mic to isolate the route.

Restart only the capture

Finish or cancel any pending sample and start a new session. Tell the app to use the correct device before pressing its shortcut. A new mic route should be tested before increasing model size or downloading anything.

Check the intended text

Repeat the same phrase once the meter is steady. If the original reads correctly but an email draft changes it, the remaining issue is formatting rather than the call’s microphone route.

Keep exploring